MATLAB XPC TARGET 4 - IO Guida Utente Scaricare il pdf (Pagina 26)

2 Advanced Procedures

2-16

6 Connect the xPC Target scope block with the Simulink scope block.

The model

xpcosc should look like the figure shown below.

Your next task is to define the xPC Target scope block parameters. See

“Defining xPC Target Scope Block Parameters”.

Defining xPC Target Scope Block Parameters

Scope block parameters define the signals to trace on the scope, trigger modes,

and the axis range.

This procedure uses the Simulink model

xpcosc.mdl as an example, and

assumes you have added an xPC Target scope block to your model. To add a

scope block, see “Adding xPC Target Scope Blocks” on page 2-13.

1 Double-click the scope block labeled Scope (xPC).

The Block Parameters dialog box for the scope block opens.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 181 182

Nessun commento

MATLAB XPC TARGET 4 - IO Guida Utente Pagina 26